The Autonerdz Community Forums - Ford Feedback carburetor

	Welcome, Guest. Please Login or Register

Home

Help

Member Map

Event Calendar

The Autonerdz Community Forums › General Public Area › Introductions › Ford Feedback carburetor

‹ Previous Topic | Next Topic ›

Pages: 1

Send Topic

Ford Feedback carburetor (Read 3,868 times)

fisher

Super Nerd
Picogroup

Offline

I love YaBB 1G - SP1!

Posts: 2,731

Concord
California
USA
Gender: male

Ford Feedback carburetor
Mar 3^rd, 2005 at 8:32pm

Hello. My name is Don.I am trying to get an F-250 Ford, '86 model with 4.9 litre six cylinder feedback carb back on it's feet.
I have a MAC ETS 2800 labscope I am testing it with.I cant send any waveforms yet.
However, should the PIP and SPOUT signal voltage be as low as 9 volts? The Battery voltage is nominal twelve volts or higher when the square wave I see on the scope is just 9 volts.

IP Logged

Tom Roberts Autonerdz Administrator Picogroup Offline Autonerdz Founder Posts: 8,595 Olympia Washington USA Gender:	Re: Ford Feedback carburetor Reply #1 - Mar 4^th, 2005 at 8:27am Hi Fisher, This should have probably been placed in the General Technical Discussion area. Normally PIP and SPOUT peak at system voltage.
Back to top	Tom Roberts Forums Administrator IP Logged

fisher Super Nerd Picogroup Offline I love YaBB 1G - SP1! Posts: 2,731 Concord California USA Gender:	Re: Ford Feedback carburetor Reply #2 - Mar 4^th, 2005 at 8:08pm Thanks Mr. Roberts, I'll take this over to that section.
Back to top	IP Logged

Pages: 1

Send Topic

‹ Previous Topic | Next Topic ›

« Home

‹ Board

Top of this page