The Autonerdz Community Forums

The Autonerdz Community Forums
https://www.autonerdz.com/cgi/yabb2/YaBB.pl General Public Area >> Test Board >> Goon 3.0 Test https://www.autonerdz.com/cgi/yabb2/YaBB.pl?num=1297988621 Message started by John Vozar on Feb 17^th, 2011 at 4:23pm

Title: Goon 3.0 Test
Post by John Vozar on Feb 17^th, 2011 at 4:23pm

Messed that up o;

Title: Re: Goon 3.0 Test
Post by John Vozar on Feb 17^th, 2011 at 4:40pm

:-[

Title: Re: Goon 3.0 Test
Post by Mick on Feb 17^th, 2011 at 4:42pm

John Vozar wrote on Feb 17^th, 2011 at 4:40pm:

:-[

John can I help you?

Mick

Title: Re: Goon 3.0 Test
Post by John Vozar on Feb 18^th, 2011 at 9:56am

Hi Mick

Nothing important, I had just down loaded Irfan View and was trying to insert an image here. Ran out of battery power on my lap top.
I'll try again tonight.

Thanks John

Title: Re: Goon 3.0 Test
Post by Mick on Feb 18^th, 2011 at 11:08am

John Vozar wrote on Feb 18^th, 2011 at 9:56am:

Hi Mick

Nothing important, I had just down loaded Irfan View and was trying to insert an image here. Ran out of battery power on my lap top.
I'll try again tonight.

Thanks John

Are the images saved as gif files?
Are they saved in a folder?
Are you selecting the image file when uploading?

leave a note if you need any help :)

Mick

Title: Re: Goon 3.0 Test
Post by John Vozar on Feb 18^th, 2011 at 3:00pm

Try number 3

Clipboard01Goon_test.jpg (115 KB | )

Title: Re: Goon 3.0 Test
Post by John Vozar on Feb 18^th, 2011 at 3:09pm

I got it now! I wasn't selecting the image file when uploading.

Thanks Mick

Title: Re: Goon 3.0 Test
Post by Mick on Feb 18^th, 2011 at 4:48pm

John Vozar wrote on Feb 18^th, 2011 at 3:09pm:

I got it now! I wasn't selecting the image file when uploading.

Thanks Mick

Glad you got it John

May I suggest one thing if you are going to show anyone your file, it would be better if the voltage, probe and sample rate setting could be seen, to do this you would have to open the Pico software and say yes when asked would you like to open a demo device, then click on the Pico scope you captured the file with.
Try it out you will see all you’re setting appear in the boxes.

Mick