Hi
I am running v6, at startup I must choose between 34xx or 32xx, 212/x...
some of the files posted here are for one version or another, how can I change over from one setup to another without having to close / reopen the program?

Sam,
Version 6 is what most of us are using, when you open Picoscope 6 and you do NOT have your hardware plugged in you are asked about demo mode, 34xx, 32xx and 212/x are different scopes.  My suggestion would be to use 3423 this is a four channel Pico scope.  This will allow you to view most of the files posted in the forums.

TCROfreak wrote on Feb 1^st, 2009 at 10:49pm:

My suggestion would be to use 3423 this is a four channel Pico scope.  This will allow you to view most of the files posted in the forums.

that is what I did. but it will not open 212-3 file as listed
http://www.autonerdz.com/cgi/yabb2/YaBB.pl?num=1233374428
#12
97_honda_civic_inj_2.psd (76 KB | 20  )

and it is asking to update to a later version to open the files attached to #3 and #8 of the same thread.
so I am downloading PicoScope6Automotive_r6_2_0.exe from picotech, should I uninstall the old version before installing the new?

Quote:

that is what I did. but it will not open 212-3 file as listed http://www.autonerdz.com/cgi/yabb2/YaBB.pl?num=1233374428 #12 97_honda_civic_inj_2.psd (76 KB | 20  )

You can install Pico 5 from the pico site this should open the file.  Pico 5 and Pico 6 can be installed on the same computer, this is what I have done.


Quote:

and it is asking to update to a later version to open the files attached to #3 and #8 of the same thread. so I am downloading PicoScope6Automotive_r6_2_0.exe from picotech, should I uninstall the old version before installing the new?

If you are updating you should not have to uninstall the old, however if you are going to install a beta test version I would uninstall first.

I just installed version: 6.2.0.18 and it works fine for all file types. thx